If the host fails authentication for the designated number of times, the
authenticator places the port in authentication failed VLAN (
dot1x auth-fail-
vlan
).
NOTE: You can create the Layer 3 portion of a guest VLAN and authentication
fail VLANs regardless if the VLAN is assigned to an interface or not. After an
interface is assigned a guest VLAN (which has an IP address), routing through
the guest VLAN is the same as any other traffic. However, the interface may
join/leave a VLAN dynamically.
Related
Commands
•
— Configure an authentication failure VLAN.
•
— Enable periodic re-authentication of the client.
•
—
Configure the maximum number of times to re-authenticate a port before it
becomes unauthorized
dot1x host-mode
Enable single-host or multi-host authentication.
S6000
Syntax
dot1x host-mode {single-host | multi-host | multi-auth}
Parameters
single-host
Enable single-host authentication.
multi-host
Enable multi-host authentication.
multi-auth
Enable multi-supplicant authentication.
Defaults
single-host
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version 9.0.0.0
Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
802.1X
155
Summary of Contents for Networking S6000 System
