Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Instroduces on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 8.3.1.0
Introduced on the C-Series and S-Series.
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
– Make packets eligible for dropping based on their DEI value.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the
vlan-stack
compatible
command in its configuration.
S6000
Syntax
member
interface
To remove an interface from a Stackable VLAN, use the
no member
interface
command.
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabyte Ethernet interface, enter the keyword
fortyGigE
then the slot/ port information.
Defaults
Not configured.
Command
Modes
CONF-IF-VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
1438
VLAN Stacking
Summary of Contents for Networking S6000 System
