Dell Networking S6000 System, Reference Manual

Page: 1230 / 1510

To delete access to a level and command, use the
no privilege mode level
level command
command.
Parameters
mode Enter one of the following keywords as the mode for which
you are controlling access:
•
configure
for CONFIGURATION mode
•
exec
for EXEC mode
•
interface
for INTERFACE modes
•
line
for LINE mode
•
route-map
for ROUTE-MAP mode
•
router
for ROUTER OSPF, ROUTER RIP, ROUTER ISIS
and ROUTER BGP modes
level level Enter the keyword
level
then a number for the access level.
The range is from 0 to 15.
Level 1 is EXEC mode and Level 15 allows access to all CLI
modes and commands.
reset Enter the keyword
reset
to return the security level to the
default setting.
command Enter the command’s keywords to assign the command to a
certain access level. You can enter one or all of the
keywords.
Defaults Not configured.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
1230
Security