13
Debugging and Diagnostics
The basic debugging and diagnostic commands are supported by the Dell Networking Operating System
(OS) on the S6000 platform.
This chapter contains the following sections:
• Offline Diagnostic Commands
• Buffer Tuning Commands
• Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the
logging coredump server
Enable the platform to send application core dumps to an FTP server.
S6000
Syntax
logging coredump server {
ftp-server
|
ip-address
|
ipv6-
address
} username (
ftp-username
|
name
} password [
type
] {
ftp-
password
|
password
}
Parameters
ftp-server
Enter the hostname or IP address of the FTP server where
Dell Networking OS sends application core dumps.
ip-address
Enter the IP address of the target server in dotted decimal
format.
ipv6-address
Enter an IPv6 address of the target server, in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
name
Enter a username to access the target server.
ftp-username
Enter the user name to access the target ftp server.
type
Enter the password type:
• Enter 0 to enter an un-encrypted password.
• Enter 7 to enter a password that has already been
encrypted using a Type 7 hashing algorithm.
500
Debugging and Diagnostics
Summary of Contents for Networking S6000 System
