Dell Networking S6000 System, Reference Manual

Page: 173 / 1510

Parameters
access-list-
name (OPTIONAL) Enter the name of a configured access-list, up
to 140 characters.
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increase the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
ip access-group
Assign an IP access list (IP ACL) to an interface.
S6000
Syntax
ip access-group access-list-name {in | out} [implicit-permit]
[vlan vlan-id ] [vrf vrf-name ]
To delete an IP access-group configuration, use the
no ip access-group
access-list-name {in | out} [implicit-permit] [vlan vlan-id ]
[vrf vrf-name ]
command.
Parameters
access-list-
name Enter the name of a configured access list, up to 140
characters.
in Enter the keyword
in
to apply the ACL to incoming traffic.
out Enter the keyword
out
to apply the ACL to outgoing traffic.
implicit-permit (OPTIONAL) Enter the keyword
implicit-permit
to
change the default action of the ACL from implicit-deny to
Access Control Lists (ACL)
173