Dell Networking S6000 System, Reference Manual, Page: 174 / 1510

implicit-permit (that is, if the traffic does not match the filters
in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword
vlan
then the ID numbers of
the VLANs. The range is from 1 to 4094 (you can use IDs
from 1 to 4094).
vrf vrf-name (OPTIONAL) Enter the keyword vrf then the ID numbers of
the VRFs. The range is from 1 to 63 (you can use IDs from 1
to 63).
NOTE: When you specify a single VRF, use the name of
the VRF instead of the VRF ID number. Use the VRF ID
numbers only when you specify a range of VRFs.
Defaults Not enabled.
Command
Modes INTERFACE/VRF MODE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0) Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information You can assign one ACL (standard or extended ACL) to an interface.
NOTE: This command supports Loopback interfaces EE3 and EF series route
processor modules (RPMs). This command does not support Loopback
interfaces ED series RPMs, S-Series Loopback interfaces.
NOTE: If outbound(egress) IP acl is applied on switch port, filter will be applied
only for routed traffic egressing out of that port.
174
Access Control Lists (ACL)