Dell Networking S6000 System, Reference Manual

Page: 661 / 1510

Native VlanId: 10
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged gi 7/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged gi 7/0
Dell(conf-if-vl-20)#interface gi 7/0
Dell(conf-if-gi-7/0)#no portmode hybrid
Dell(conf-if-vl-20)#
Related
Commands
show interfaces switchport — displays the configuration of switchport (Layer 2)
interfaces on the switch.
switchport — places the interface in a Layer 2 mode.
vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN
network.
rate-interval
Configure the traffic sampling interval on the selected interface.
S6000
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data.
The range is from 5 to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the
number of seconds designated here rounds to the
multiple of 15 seconds lower than the entered value. For
example, if 44 seconds is designated, it rounds to 30; 45
to 59 seconds rounds to 45.
Defaults 299 seconds
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Interfaces
661