Dell Networking S6000 System, Reference Manual

Page: 998 / 1510

network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
S6000
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the
no network ip-address mask area area-
id
command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal
format. The primary address is required before adding the
secondary address.
mask Enter a network mask in /prefix format. (/x)
area-id Enter the OSPF area ID as either a decimal value or in a valid
IP address. Decimal value range is from 0 to 65535. IP
address format is dotted decimal format A.B.C.D.
NOTE: If the area ID is smaller than 65535, it is converted
to a decimal value. For example, if you use an area ID of
0.0.0.1, it is converted to 1.
Command
Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced to all platforms.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information
To enable OSPF on an interface, the
network area
command must include, in its
range of addresses, the primary IP address of an interface.
998
Open Shortest Path First (OSPFv2 and OSPFv3)