log-adjacency-changes
Generate a log messages for adjacency state changes.
S6000
Syntax
log-adjacency-changes
To disable this function, use the
no log-adjacency-changes
command.
Defaults
Adjacency changes are not logged.
Command
Modes
ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1
Introduced on the Z9000.
Usage
Information
This command allows you to monitor adjacency state changes, which are useful
when you monitor large networks. Messages are logged in the system’s error
message facility.
lsp-gen-interval
Set the minimum interval between successive generations of link-state packets (LSPs).
S6000
Syntax
lsp-gen-interval [level-l | level-2]
interval seconds
[
initial_wait_interval seconds
[
second_wait_interval seconds
]]
To restore default values, use the
no lsp-gen-interval [level-l |
level-2]
interval seconds
[
initial_wait_interval seconds
[
second_wait_interval seconds
]]
command.
Parameters
level-l
(OPTIONAL) Enter the keywords
level-1
to apply the
configuration to generation of Level-1 LSPs.
826
Intermediate System to Intermediate System (IS-IS)
Summary of Contents for Networking S6000 System
