Dell Networking S6000 System, Reference Manual

Page: 455 / 1510

To remove only the DCB input policies applied to the specified switch, use the
no
dcb-policy input stack-unit
command.
Parameters
stack-unit-id Enter the stack unit identification.
dcb-input-
policy-name Enter the policy name for the DCB input policy.
Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
The
dcb-policy input stack-unit all
command overwrites any previous
dcb-policy input stack-unit stack-unit-id
configurations. Similarly, a
dcb-policy input stack-unit stack-unit-id
command overwrites any
previous
dcb-policy input stack-unit all
configuration.
pfc no-drop queues
Configure the port queues that still function as no-drop queues for lossless traffic.
S6000
Syntax
pfc no-drop queues queue-range
To remove the no-drop port queues, use the
no pfc no-drop queues
command.
Parameters
queue-range Enter the queue range. Separate the queue values with a
comma; specify a priority range with a dash; for example,
Data Center Bridging (DCB)
455