ip proxy-arp
Enable proxy ARP on an interface.
S6000
Syntax
ip proxy-arp
To disable proxy ARP, use the
no ip proxy-arp
command.
Defaults
Enabled.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 8.1.1.0
Introduced on the E-Series ExaScale.
Version 7.6.1.0
Introduced on the S-Series.
Version 7.5.1.0
Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
— displays the interface routing status and configuration.
ip route
Assign a static route to the switch.
S6000
Syntax
ip route [vrf
vrf-name
] ip-address mask {
ip-address
| interface
[
ip-address
]} [
distance
] [permanent] [tag
tag-value
] [vrf
vrf-
name
]
To delete a specific static route, use the
no ip route
destination mask
command.
IPv4 Routing
733
Summary of Contents for Networking S6000 System
