Dell Networking S6000 System, Reference Manual

Page: 755 / 1510

Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.10.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information
This command provides egress port information for a given IP flow. This
information is useful in identifying which interface the packet follows in the case of
Port-channel and Equal Cost Multi Paths. Use this command for routed packed
only. For switched packets, use the
show port-channel-flow
command.
The
show ip flow
command does not compute the egress port information
when
load-balance mac hashing
is also configured due to insufficient
information (the egress MAC is not available).
S-Series produces the following error message:
%Error: Unable to read IP
route table
.
Example
Dell#show ip flow interface Gi 1/8 189.1.1.1 63.0.0.1 protocol
tcp source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface:Gi 1/20
Egress interface:Gi 1/14 to 1.7.1.2[CAM hit 103710]
unfragmented packet
Gi 1/10 to 1.2.1.2[CAM hit 103710] fragmented
packet
show ip interface
View IP-related information on all interfaces.
S6000
Syntax
show ip interface [ interface | brief] [configured]
IPv4 Routing
755