Dell Networking S6000 System, Reference Manual

Page: 1325 / 1510

Defaults Disabled.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information Dell Networking OS enhances the sflow implementation for real time traffic
analysis on the E-Series to provide extended gateway information in cases where
the destination IP addresses are learned by different routing protocols and for
cases where the destination is reachable over ECMP.
Related
Commands
show sflow — displays the sFlow configuration.
sflow polling-interval (Global)
Set the sFlow polling interval at a global level.
S6000
Syntax
sflow polling-interval interval value
To return to the default, use the
no sflow polling-interval interval
command.
Parameters
interval value Enter the interval value in seconds. The range is from 15 to
86400 seconds. The default is
20 seconds .
Defaults 20 seconds
sFlow
1325