Dell Networking S6000 System, Reference Manual, Page: 1269 / 1510

To delete the authentication failure VLAN, use the
no dot1x auth-fail-vlan
vlan-id [max-attempts number ]
command.
Parameters
vlan-id Enter the VLAN Identifier. The range is from 1 to 4094.
max-attempts
number
(OPTIONAL) Enter the keywords
max-attempts
then
number of attempts desired before authentication fails. The
range is from 1 to 5. The default is
3 .
Defaults 3 attempts
Command
Modes CONFIGURATION (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series, S-Series, and E-Series.
Usage
Information
If the host responds to 802.1X with an incorrect login/password, the login fails. The
switch attempts to authenticate again until the maximum attempts configured is
reached. If the authentication fails after all allowed attempts, the interface is moved
to the authentication failed VLAN.
After the authentication VLAN is assigned, the port-state must be toggled to restart
authentication. Authentication occurs at the next re-authentication interval (
dot1x
reauthentication
).
Related
Commands
dot1x port-control — enables port-control on an interface.
dot1x guest-vlan — configures a guest VLAN for non-dot1x devices.
show dot1x interface — displays the 802.1X information on an interface.
dot1x auth-server
Configure the authentication server to RADIUS.
S6000
Syntax
dot1x auth-server radius
Security
1269