Dell Networking S6000 System, Reference Manual, Page: 202 / 1510

host ip-address Enter the keyword
host
and then enter the IP address to
specify a host IP address.
dscp Enter the keyword
dscp
to deny a packet based on the
DSCP value. The range is from 0 to 63.
operator (OPTIONAL) Enter one of the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports (you must specify two
ports for the
port
parameter)
port port Enter the application layer port number. Enter two port
numbers if you are using the
range
logical operand. The
range is 0 to 65535.
destination Enter the IP address of the network or host to which the
packets are sent.
count (OPTIONAL) Enter the keyword
count
to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword
byte
to count bytes
processed by the filter.
order (OPTIONAL) Enter the keyword
order
to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword
order
, the ACLs have the lowest order by default
(255).
fragments Enter the keyword
fragments
to use ACLs to control packet
fragments.
Defaults Not configured.
Command
Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
202
Access Control Lists (ACL)