Dell Networking S6000 System, Reference Manual, Page: 1043 / 1510

Usage
Information
The
area range
command summarizes routes for the different areas.
With the
not-advertise
parameter configured, you can use this command to
filter out some external routes. For example, if you want to redistribute static routes
to OSPF, but you don't want OSPF to advertise routes with prefix 1.1.0.0, you can
configure the summary-address 1.1.0.0 255.255.0.0 not-advertise to filter out all
the routes fall in range 1.1.0.0/16.
Related
Commands area range — summarizes routes within an area.
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path first
(SPF) calculation.
S6000
Syntax
timers spf delay holdtime
To return to the default, use the
no timers spf
command.
Parameters
delay Enter a number as the delay. The range is from 0 to
4294967295. The default is
5 seconds .
holdtime Enter a number as the hold time. The range is from 0 to
4294967295. The default is
10 seconds .
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
Command
Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Open Shortest Path First (OSPFv2 and OSPFv3)
1043