Dell Networking S6000 System, Reference Manual, Page: 501 / 1510

password Enter a password to access the target server.
ftp-password Enter the password of the target ftp server where the
application core dump files will be uploaded. The password
can be up to 15 alphanumeric characters; no special
characters are allowed.
Defaults Crash kernel files are uploaded to flash by default.
Command
Modes CONFIGURATION
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Added information about ftp password and URL to Usage
Information .
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.1.0 Added support for IPv6.
Version 7.7.1.0 Restructured the command to accommodate core dumps
for CP. Introduced on the C-Series and S-Series.
Version 6.1.1.0 Introduced
Usage
Information
You must use this command to enable core dump logging before a software
exception occurs. If the FTP server is unreachable, Dell Networking OS aborts the
application core dump.
When you enable this command to allow the system to automatically upload
application core dumps to an FTP server, you are requested to enter a username
and password. Use the username and password of the FTP server where the core
files are being moved. The password can be up to 15 alphanumeric characters only;
no special characters are allowed. After you enter the password, an FTP URL is
created with the credentials in the operating system. The CLI monitors application
core dumps in the unit. Any application core dumps that occur are automatically
uploaded to the FTP server.
Because flash space may be limited, using this command ensures your entire crash
kernel files are uploaded successfully and completely. You can only configure a
single coredump server. Configuration of a new coredump server over-writes any
previously configured server.
NOTE: You must disable logging coredump before you designate a new server
destination for your core dumps.
Debugging and Diagnostics
501