Dell Networking S6000 System, Reference Manual

Page: 1101 / 1510

tc-flush-standard
Enable the MAC address flushing after receiving every topology change notification.
S6000
Syntax
tc-flush-standard
To disable, use the
no tc-flush-standard
command.
Defaults Disabled.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced.
Usage
Information By default, Dell Networking OS implements an optimized flush mechanism for
PVST+. This implementation helps in flushing the MAC addresses only when
necessary (and less often) allowing for faster convergence during topology
changes. However, if a standards-based flush mechanism is needed, you can turn
this
knob command on to enable flushing MAC addresses after receiving every
topology change notification.
vlan bridge-priority
Set the PVST+ bridge-priority for a VLAN or a set of VLANs.
S6000
Syntax
vlan vlan-range bridge-priority value
To return to the default value, use the
no vlan bridge-priority
command.
Per-VLAN Spanning Tree Plus (PVST+)
1101