Usage
Information
PFC and ETS settings are not pre-configured on Ethernet ports. You must use the
dcb-map
command to configure different groups of 802.1p priorities with PFC and
ETS settings.
Using the
priority-pgid
command, you assign each 802.1p priority to one
priority group. A priority group consists of 802.1p priority values that are grouped
together for similar bandwidth allocation and scheduling, and that share latency
and loss requirements. All 802.1p priorities mapped to the same queue must be in
the same priority group. For example, the
priority-pgid 0 0 0 1 2 4 4 4
command creates the following groups of 802.1p priority traffic:
• Priority group 0 contains traffic with dot1p priorities 0, 1, and 2.
• Priority group 1 contains traffic with dot1p priority 3.
• Priority group 2 contains traffic with dot1p priority 4.
• Priority group 4 contains traffic with dot1p priority 5, 6, and 7.
To remove a priority-pgid configuration from a DCB map, enter the
no
priority-pgid
command.
priority-group bandwidth pfc
Configure the ETS bandwidth allocation and PFC mode used to manage port traffic in an 802.1p priority
group.
S6000
Syntax
priority-group
group-num
{bandwidth
percentage
| strict-
priority} pfc {on | off}
Parameters
priority-group
group-num
Enter the keyword
priority-group
followed by the
number of an 802.1p priority group. Use the
priority-
pgid
command to create the priority groups in a DCB map.
bandwidth
percentage
Enter the keyword
bandwidth
followed by a bandwidth
percentage allocated to the priority group. The range of valid
values is 1 to 100. The sum of all allocated bandwidth
percentages in priority groups in a DCB map must be 100%.
strict-priority
Configure the priority-group traffic to be handled with strict
priority scheduling. Strict-priority traffic is serviced first,
before bandwidth allocated to other priority groups is made
available.
pfc {on | off}
Configure whether priority-based flow control is enabled
(on) or disabled (off) for port traffic in the priority group.
Defaults
None
Data Center Bridging (DCB)
481
Summary of Contents for Networking S6000 System
