Page 1
XSNet C6108SW
Quick Start guide
1 Unpacking
Unpack the items. Your package should
include:
One XSNet C6108SW hardened managed
switch
2 What Else You Need
Category 5 or better cable for RJ-45 ports
SFP module and corresponding fiber cables
for SFP slot.
PC with a DB9 straight cable
3 Select a Location
DIN-Rail, wall, and rack mount installation
Identify a power source within 6 feet (1.8
meters).
Choose a dry area with ambient temperature
between -40 and 75ºC (-40 and 167ºF).
Keep away from heat sources, sunlight, warm
air exhausts, hot-air vents, and heaters.
Be sure there is adequate airflow.
4 Connect to the Data Ports
The managed switch is equipped with the
following ports:
Eight 10/100/1000BASE-TX ports
Four 1000BASE SFP slots
10/100/1000BASE-TX Ports
These ports can connect to devices such as
an IP surveillance camera or a Voice Over
Internet Protocol (VoIP) phone.
A.
Insert one end of an appropriate cable into a
switch port. x
B.
Connect the other end into the Ethernet port
of the device.
C.
Repeat steps A and B for each additional
device you want to connect to the switch.
1000BASE SFP Slots
Insert the SFP module and connect the
appropriate fiber cabling
Note that XSNet Series manuals may cover
multiple models. To establish if a particular
feature or specification in this manual
applies to the unit at hand, consult the
datasheet of the given model.
Note: The EU Declaration of Conformity for
this product can be found at
www.siqura.com/support-files.
