Dell Networking S6000 System, Reference Manual

Page: 1111 / 1510

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information
The
dot1p-priority
command changes the priority of incoming traffic on the
interface. The system places traffic marked with a priority in the correct queue and
processes that traffic according to its queue.
When you set the priority for a port channel, the physical interfaces assigned to the
port channel are configured with the same value. You cannot assign the
dot1p-
priority
command to individual interfaces in a port channel.
rate police
Police the incoming traffic rate on the selected interface.
S6000
Syntax
rate police [kbps] committed-rate [ burst-KB ] [peak [kbps] peak-
rate [ burst-KB ]] [vlan vlan-id ]
Parameters
kbps Enter the keyword
kbps
to specify the rate limit in Kilobits
per second (Kbps). The range is from 0 to 40000000. The
default granularity is Megabits per second (Mbps).
committed-
rate Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is
50 .
peak peak-rate (OPTIONAL) Enter the keyword
peak
then a number to
specify the peak rate in Mbps. The range is from 0 to 4000.
vlan vlan-id (OPTIONAL) Enter the keyword
vlan
then a VLAN ID to
police traffic to those specific VLANs. The range is from 1 to
4094.
Defaults Granularity for
commited-rate
and
peak-rate
is Mbps unless you use the
kbps
option.
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Quality of Service (QoS)
1111