Dell Networking S6000 System, Reference Manual, Page: 1390 / 1510

Version 6.5.1.0 Introduced on the E-Series.
Usage
Information Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2
broadcast traffic is treated as unknown-unicast traffic.
storm-control broadcast (Interface)
Configure the percentage of broadcast traffic allowed on an interface (ingress only).
S6000
Syntax
storm-control broadcast [ packets_per_second in]
To disable broadcast storm control on the interface, use the
no storm-control
broadcast [ packets_per_second in]
command.
Parameters
packets_per_se
cond
in
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Defaults none
Command
Modes INTERFACE (conf-if- interface-slot/port )
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 E-Series Only: Added the
percentage decimal value
option.
Version 6.5.1.0 Introduced on the E-Series.
1390
Storm Control