Dell Networking S6000 System, Reference Manual

Page: 1395 / 1510

50
Spanning Tree Protocol (STP)
The commands in this chapter configure and monitor the IEEE 802.1d spanning tree protocol (STP) and
are supported on the S6000 Dell Networking switch/routing platform.
bridge-priority
Set the bridge priority of the switch in an IEEE 802.1D spanning tree.
S6000
Syntax
bridge-priority { priority-value | primary | secondary}
To return to the default value, use the
no bridge-priority
command.
Parameters
priority-value Enter a number as the bridge priority value. The range is
from 0 to 65535. The default is
32768 .
primary Enter the keyword
primary
to designate the bridge as the
root bridge.
secondary Enter the keyword
secondary
to designate the bridge as a
secondary root bridge.
Defaults priority-value = 32768
Command
Modes SPANNING TREE (The prompt is “config-stp”.)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Spanning Tree Protocol (STP)
1395