5-(32)
Using BUSY Signals
Section 5-6
STEP in Measure
Measurement will not be performed by the Controller during another measure-
ment, even if the STEP signal turns ON. Set whether or not the ERR signal will
turn ON to notify the external device that the STEP signal was not accepted.
Note
*The asterisk (*) indicates the default setting.
1.
Enter System mode and select Measurement control.
SeeAlso
Refer to
(QWHULQJ6\VWHP0RGH
.
The Measurement Control Settings Screen will be displayed.
2.
Change the STEP in measure and BUSY range settings.
3.
Select End.
The settings are registered and the System Mode Screen will return.
Selection
Details
ERR ON* (See note.) Measurement will not be performed and the ERR signal will
turn ON if the STEP signal turns ON during processing. The
ERR signal will turn OFF when the next STEP signal is input at
the correct timing.
OFF
The ERR signal will not turn ON even if the STEP signal turns
ON during processing. Measurement will not be performed.
End
Measurement control
Image storage
STEP in measure
BUSY range
:
:
All
ERR ON
: Measurement