2-12-(13)
Detecting Binary Defects
Section 2-12
2.
Select either Correct or Clear and press the ENT Key.
If Correct is selected, the cursor will be displayed. Correct the size and po-
sition of the figure as desired.
If Clear is selected, the selected figure will be cleared.
STEP 4: Re-registering Reference Values
This operation is performed when only the reference values are to be re-regis-
tered.
When a measurement region is drawn, the measurement is performed for the
displayed image and the results are registered as the reference values. If the
re-registering function explained here is used, only the reference values for the
image currently displayed will be registered. The area and center of gravity are
registered for the reference values.
CHECK
Reference positions can also be changed, facilitating the following application.
Inspecting Positions from a Specified Point
Once the reference values (area and center of gravity) have been obtained for
the image currently displayed, the reference position is changed to an suitable
point. Position inspection can be performed by calculating the difference
between this reference position and the measurement position.
CHECK
When the measurement region is changed, the reference values return to the
default settings.
1.
Select Reference registration.
Reference position
Measurement position (gravity)
changed to suitable point
Region0(Gravity and area)
Binary
Measurement conditions
Region
Reference registration
Judgement conditions
Detailed conditions
Clear
