2-19-(14)
EC Circle Count
Section 2-19
2-19-7
Setting Detailed Conditions
Adjust the detailed conditions if the circle detection is unstable or if circles of
different sizes are counted.
CHECK
Finding Circles
1.
Extracting Circle Candidates
Size: Set under Candidate radius.
SeeAlso
Refer to page 2-19-(10).
Extraction: Performed based on pixel skipping setting.
2.
Judging Whether or Not Candidate Circle Should Be Counted
Deformity check: Is the circle within the circular value range?
Size check:
Is the circle within the radius range?
The asterisk (*) indicates the default setting.
1.
Select Detailed conditions.
The Detailed Conditions Settings Screen will be displayed.
End
Detailed conditions
Skipping
Circular value
Radius
[ 1.000:512.000]
:
:
:
ON
[ 0]%
Select whether pixel skipping (1 pixel) will be used
when searching for circle candidates. (ON*, OFF)
Processing is faster if pixel skipping is ON and normally
it is appropriate to set pixel skipping to ON. However, if
the measurement values vary, set to OFF.
Circle deformity check (0 to 100 (0*))
If the circle is deformed or chipped, the evaluation is
lower. Any figure with an evaluation lower than the setting
here will not be counted as a circle.
Set the radius for circles to be counted. (1.000 to 9999.999 (1.000 to 512.000*))
Candidate circles that do not fall within this radius range are not counted.
1.EC circle count
Measurement image
Extract edges
Measurement conditions
Inspected region
Candidate radius
Judgement conditions
Detailed conditions
Coordinate mode
End
Detailed conditions
Skipping
Circular value
Radius
[ 1.000:512.000]
:
:
:
ON
[ 0]%
