5-(21)
Customizing Operations
Section 5-4
5-4-2
Capturing and Saving Images
Turn ON the display capture function to capture the image displayed on the
monitor screen and save it to the Memory Card.
Stored images can be pasted to documents on a personal computer or loaded
to the Controller and re-measured.
The default setting is OFF.
CHECK
• The capture operation takes several seconds, during which measurement
cannot be performed. To prevent incorrect operation, set this function to
OFF.
• When the image display is set to Last NG, captured images are not
accepted.
1.
Enter System mode and select Operation settings.
SeeAlso
Refer to
(QWHULQJ6\VWHP0RGH
.
The Menu will be displayed.
2.
Select Display capture.
The Display Capture Screen will be displayed.
3.
Set the display capture function to either ON or OFF.
4.
Select the destination output Memory Card drive.
5.
Select End.
The settings will be registered and the screen in (1.) will return.
Execution Keys
The following keys execute display capture when the display capture function
is turned ON.
• For F160-KP: F9 Key
• For F150-KP: SHIFT+Left+Right Keys (Press 3 keys at the same time.)
CHECK
In Monitor and Run Modes only, the display capture function can be allocated
to another key. For example, the key allocation can be changed when the
F150-KP is being used to enable one-touch operation, rather than having to
press three keys at the same time. However, if display capture is allocated to
another key, care must be taken because that key will be enabled in Monitor
and Run Modes even if Display capture is set to OFF. Refer to
&XVWRPL]LQJ
2SHUDWLRQV
.
Set key operation
Display capture
Save at switch Scn Group
Password
Nonstop/Fast
End
Display capture
Display capture
Output drive
:
:
OFF
C1