2-25-(9)
Labeling
Section 2-25
The figure will be registered.
6.
If additional figures are to be drawn, select Add.
7.
Repeat steps 3 to 5 as necessary to create the desired shape.
8.
After drawing is completed, select End.
The measurement region will be registered and the screen in (1.) will re-
turn. The center of gravity (display cursor) and measurement region will be
displayed.
CHECK
Figures drawn using OR mode are displayed with solid lines and figures drawn
using NOT mode are displayed with dotted lines.
CHECK
Set the model region so that no more than three areas lie along any one
straight line.
Region
Add
Figure0
End
Once three figures have been drawn,
Add will no longer be displayed.
Figure 1 (drawn using OR)
Figure 2 (drawn using NOT)
Figure 3 (drawn using OR)
1
2
3
4
INCORRECT
Rectangle (drawn using OR)
Circumference (drawn using NOT)
Circle (drawn using NOT)
