Mitsubishi Electric FR-A800, Instruction Manual

Page: 883 / 1042

Parameters Copying and verifying parameters on the operation panel
FR-A800 5 - 703
5.18.2 Parameter verification
Whether the parameter settings of inverters are the same or not can be checked.
NOTES ●
appears... Why?
Parameter write error. Perform the operation from step again.
●
and are displayed alternately.
Appears when parameter copy is performed between inverters FR-A820-03160(55K) or lower
or inverters FR-A840-01800(55K) or lower and inverters FR-A820-03800(75K) or higher or FR-
A840-02160(75K) or higher.
When CP and 0.00 flicker alternately, set the Pr. 989 "Parameter copy alarm release" as shown
below (initial value):
After setting Pr. 989, perform setting of Pr. 9, Pr. 30, Pr. 51, Pr. 56, Pr. 57, Pr. 61, Pr. 70, Pr. 72, Pr.
80, Pr. 82, Pr. 90 to Pr. 94, Pr. 453, Pr. 455, Pr. 458 to Pr. 462, Pr. 557, Pr. 859, Pr. 860, and Pr. 893
again.
Operation
Copy the parameter settings of the verification source inverter to operation panel according to the procedure on page
5-702.
Move the operation panel to the inverter to be verified.
Screen at power-ON
The monitor display appears.
#
Parameter setting mode
Press to choose the parameter setting mode. (The parameter number read previously appears.)
,
Selecting the parameter number
Turn to (parameter copy). Press . " " appears.
$
Parameter verification
Turn to change to setting value " " (parameter copy verification mode).
Press . Verification of the parameter settings copied to the operation panel and the parameter settings of the
verification destination inverter is started. (It takes about 60 seconds to verify all the settings. During verification,
" " flickers.)
앫
If there are different parameters, the different parameter number and " " flicker.
앫
To continue verification, press .
%
" " and " " flicker alternately after verification ends.
Tab. 5-322: Parameter verification
NOTE
flickers... Why?
The set frequency may be incorrect. To continue verification, press SET key.
Pr. 989 setting Operation
10 Cancels the alarm of FR-A820-03160(55K) or lower and FR-A840-01800(55K) or lower.
100 Cancels the alarm of FR-A820-03800(75K) or higher and FR-A840-02160(75K) or higher.