Mitsubishi Electric FR-A800, Instruction Manual

Page: 242 / 1042

Control method Parameters
5 - 62
Valid/invalid status of monitor outputs during the test run
 : Valid
×: Invalid (always displays 0)
Δ: Displays accumulated value before the test
⎯ : Not monitored
Different output interface (operation panel, parameter unit, terminal FM/CA or terminal AM) can
output different monitored items. For details, refer to page 5-341.
When the operation is switched to the test run, "0" is displayed. When PM sensorless vector control
is selected again after a test run, the output current peak value and the electronic thermal relay
load factor from the last operation are displayed.
The monitored status can be output via the terminal AM only.
#
When the operation is switched to the test run, accumulated thermal value is reduced by consid-
ering the output current is "0".
Types of monitor
DU/PU
Monitor
display
FM/AM/
CA
Output
Types of monitor
DU/PU
Monitor
display
FM/AM/
CA
Output
Output frequency
 
PID deviation
 
Fault display

⎯
Input terminal status

⎯
Frequency setting value
 
Output terminal status
 ⎯
Running speed
 
Option input terminal status

⎯
Converter output voltage
 
Option output terminal status
 ⎯
Electric thermal relay load
factor
× ×
Motor thermal load factor

#

#
Output current peak value × × Inverter thermal load factor

#

#
Converter output voltage peak
value
 
PTC thermistor value

⎯
Load meter
 
PID measured value 2
 
Cumulative energization time

⎯
Remote output 1
 
Reference voltage output
⎯ 
Remote output 2
 
Actual operation time

⎯
Remote output 3
 
Cumulative power Δ
⎯
Remote output 4
 
Trace status

× PID manipulated amount


Station number
(RS-485 terminals)

⎯
Second PID set point
 
Station number (PU connector)

⎯
Second PID measured value
 
Station number (CC-Link)

⎯
Second PID deviation


Energy saving effect
 
Second PID measured value 2
 
Cumulative energy saving Δ
⎯
Second PID manipulated amount


PID set point
 
Dancer main speed setting
 
PID measured value
 
Tab. 5-19: Monitor outputs during the test run
Parameters referred to
Pr. 52 Operation panel main monitor selection => page 5-327
Pr. 158 AM terminal function selection => page 5-341