Mitsubishi Electric FR-A800, Instruction Manual

Page: 640 / 1042

(C) Motor constant parameters Parameters
5 - 460
●
Monitor is displayed on the operation panel during tuning as below.
●
When offline auto tuning ends, press STOP/RESET key on the operation panel during PU operation.
For External operation, turn OFF the start signal (STF signal or STR signal).
This operation resets the offline auto tuning, and the PU's monitor display returns to the normal
indication.
(Without this operation, next operation cannot be started.)
Pr. 96 (Pr. 463)
Setting
1 11 1 11
(1) Setting
Operation panel (FR-DU08) display
LCD operation panel (FR-LU08)
display
(2) During tuning
(3) Normal
completion
Tab. 5-189: Display during tuning (monitor display)
NOTES The motor constants measured once in the offline auto tuning are stored as parameters and their
data are held until the offline auto tuning is performed again. However, the tuning data is cleared
by performing all parameter clear.
Changing Pr. 71 after tuning completion will change the motor constant. For example, if Pr. 71 =
"8093" is set after tuning is performed with Pr. 71 ="8090", the tuning data becomes invalid. Set
Pr. 71 = "8090" again for using the tuning data.
AutoTune 12:34
TUNE
1
--- STOP PU
PREV NEXT
AutoTune 12:34
TUNE
11
--- STOP PU
PREV NEXT
AutoTune 12:34
TUNE
2
STF FWD PU
PREV NEXT
AutoTune 12:34
TUNE
12
STF FWD PU
PREV NEXT
Flickering
Flickering
Flickering
Flickering
AutoTune 12:34
TUNE
Completed
3
STF STOP PU
PREV NEXT
AutoTune 12:34
TUNE
Completed
13
STF STOP PU
PREV NEXT