Suzuki RA410, Manual

Page: 630 / 761

HEADLIGHT AIMING WITH SCREEN
NOTE:
Unless otherwise obligated by local regulations, adjust
headlight aiming according to following procedure.
After replacing headlight, be sure to adjust aiming.
Before adjustment, make sure the following.
a) Place vehicle on a flat surface in front of blank wall (screen) (1)
ahead of headlight surface.
Clearance “a”: 10 m (32.8 ft.)
b) Adjust air pressure of all tires to a specified value respectively.
c) Bounce vehicle body up and down by hand to stabilize suspen-
sion.
d) Carry out with one driver aboard.
Driver’s weight: 75 kg (165 Ib)
Adjustment
1) Check to see if hot spot (high intensity zone) of each main (low)
beam axis falls as illustrated.
Clearance “H”: Approx. 130 mm (5.15 in.)
2) Align headlight aiming to specification by adjusting aiming
screw and aiming gear if it is not set properly.
X - X: Horizontal center line of headlights bulb
A - A: Vertical center line of left headlight bulb
B - B: Vertical center line of right headlight bulb
1. Headlight assembly
2. Aiming (for right/left adjustment)
3. Aiming (for up/down adjustment)
2
3
1
A B
Y
“H” “H”
A B
LH. HEADLIGHT RL. HEADLIGHT
HOT
SPOT
8-14 BODY ELECTRICAL SYSTEM