Suzuki RA410, Manual

Page: 756 / 761

DEPLOYMENT/ACTIVATION INSIDE VE-
HICLE
Use this procedure when scrapping the entire vehicle including the
air bag (inflator) modules and seat belt pretensioners.
CAUTION:
When vehicle itself will be used again, deploy/activate
the air bag and pretensioner outside vehicle according
to DEPLOYMENT/ACTIVATION OUTSIDE VEHICLE, for
deploying/activating it inside will cause the instrument
panel, glove box and their vicinity to be deformed.
Failure to observe this CAUTION may require unneeded
vehicle inspection and repair.
1) Turn ignition switch to “LOCK” position, remove key and put on
safety glasses.
2) Remove all loose objects from front seats and instrument panel.
3) [For driver air bag (inflator) module]
Disconnect contact coil connector (Yellow connector) located
near the base of the steering column.
[For passenger air bag (inflator) module]
Remove glove box from instrument panel and disconnect pas-
senger air bag (inflator) module connector (Yellow connector).
[For seat belt pretensioner]
Remove both side (driver and passenger side) center pillar low-
er trim (1) and disconnect seat belt pretensioner connectors
(Yellow connectors).
4) Confirm that each air bag (inflator) module is securely mounted.
For Driver Air Bag (Inflator) Module
For Passenger Air Bag (Inflator) Module
For Seat Belt Pretensioner
5) Check that there is no open, short or damage in special tool (de-
ployment harness). If any faulty condition is found, do not use
it and be sure to use new deployment harness.
Special Tool
(A): 09932-75030
6) Short (1) the two deployment harness leads together by fully
seating one banana plug into the other.
7) Connect deployment harness connector to air bag (inflator)
module (driver or passenger) or seat belt pretensioner (driver
or passenger) and lock connector with lock lever.
a) Connect connector.
b) Lock connector with lock lever.
For Driver Air Bag (inflator) Module
WARNING:
Deployment harness shall remain shorted and not be
connected to a power source until the air bag is to be
deployed and seat belt pretensioner is to be activated.
(A)
b)
a)
a)
1
AIR BAG SYSTEM 10B-61