D
Evacuate and charge system according to previously described
procedure.
D
Adjust heater control cable, refer to HEATER CONTROL LE-
VER ASSEMBLY in HEATER AND VENTILATION section.
D
Enable air bag system, if equipped.
D
Install the cutting part of drain hose (2) downward as shown in
figure.
2
INSPECTION
Check the following
D
Evaporator fins for leakage, blockage and damage.
D
Evaporator fitting for leakage.
Clogged evaporator fins should be washed with water, and should
be dried with compressed air.
NOTE:
D
Be careful not to damage evaporator fins. If evaporator fin
is bent, straighten it by using a screwdriver or pair of pliers,
If any leakage is found from fitting or tube, repair or replace
evaporator.
D
When the thermistor removed, its should be reinstalled in
original position.
A/C EVAPORATOR THERMISTOR
Check resistance between terminals.
If check results are as not specified, replace thermistor.
NOTE:
When the thermistor removed, its should be reinstalled in
original position.
1
8
7
6.65
2
0
1
5
3
4
6
0
5
10
15
20
25
_
C
–5
30
40
50
60
70
77
_
F
23
Resistance
(k
)
AIR CONDITIONING (OPTIONAL)
1B-17
Sensor Temperature (
C (
F))
Resistance (k
)
0 (32)
6.3 – 7.0
25 (77)
1.8 – 2.2
Summary of Contents for RA410
