Suzuki RA410, Manual

Page: 65 / 761

ON-VEHICLE SERVICE
CAUTION:
When refrigerant line must be disconnected and connected to remove and reinstall any component
of A/C system, be sure to observe the following instructions.
When disconnecting any line from the system, install a bling plug or cap to fitting of such line im-
mediately.
When connecting hoses and pipes to each other respectively, previously apply a few drops of re-
frigerating oil to seats of coupling nuts and O-ring.
When tightening or loosening a fitting, use two wrenches, one for turn and the other for support.
Tighten flared nuts to the following specifications.
8 mm pipe: 13 N·m (1.3 kg-m, 9.5 lb-ft)
14.5mm pipe: 32 N·m (3.2 kg-m, 23.0 lb-ft)
A/C CONDENSER ASSEMBLY
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Recover refrigerant from refrigeration system by using recovery
and recycling equipment.
3) Remove front bumper. Refer to FRONT BUMPER in BODY
SERVICE Section.
4) Remove left side head light assembly (1).
5) Loosen radiator mounting bolt (2).
6) Disconnect discharge hose (3) and condenser outlet pipe (4).
7) Loosen condenser mouting bolt (5).
8) Remove condenser assembly (6).
2
3
5
6
4
1
INSTALLATION
Reverse removal sequnce to install condenser, noting the follow-
ing point.
If condenser is replaced, pour 15 cc of refrigerating oil to com-
pressor suction-side.
Evacuate and charge system according to previously described
procedure.
AIR CONDITIONING (OPTIONAL) 1B-13