Suzuki RA410, Manual

Page: 467 / 761

MAGNETIC SWITCH
Push in plunger and release it. The plunger should return quickly
to its original position. Replace if necessary.
Pull-in Coil Open Circuit Test
Check for continuity across magnetic switch ‘S’ terminal (1) and ‘M’
terminal (2). If no continuity exists, the coil is open and should be
replaced.
2
1
Hold-in Coil Open Circuit Test
Check for continuity across magnetic switch ‘S’ terminal (1) and
coil case. If no continuity exists, the coil is open and should be re-
placed.
1
ASSEMBLY
Reverse disassembly procedure, using care on the following
points.
When installing pinion drive lever, refer to figure in page 6G-3 for
its installation direction.
When installing brush holder (1) to yoke (2), be careful of brush
positions (3).
Apply grease to current part referring to figure in page 6G-3.
2
1
3
CRANKING SYSTEM 6G-11