Suzuki RA410, Manual

Page: 463 / 761

3) Loosen 2 bolts and 2 screws to remove rear bracket.
4) Separate front housing (1) and armature (2) from yoke (3).
1
2
3
5) Draw brushes (1) out of holder (2).
1
2
6) Draw stop ring (1) toward clutch side and remove snap ring (2)
and slide off over-running clutch (3).
1
2
3
INSPECTION
ARMATURE
Inspect commutator (1) for dirt or burn. Correct with sandpaper or
lathe, if necessary.
1
Check commutator (1) for uneven wear with armature supported
on V-blocks (2). If deflection of dial gauge (3) pointer exceeds limit,
repair or replace.
NOTE:
Below specification presupposes that armature is free from
bend. Bent shaft must be replaced.
Commutator out of round
Standard: 0.05 mm (0.0019 in.) or less
Limit : 0.4 mm (0.015 in.)
3
1
2
2
CRANKING SYSTEM 6G-7