Suzuki RA410, Manual

Page: 228 / 761

4) Remove wheel cylinder mounting bolts. Disconnect brake pipe
from wheel cylinder and put bleeder plug cap (1) onto pipe to
prevent fluid from spiling.
INSPECTION
Inspect wheel cylinder disassembled parts for wear, cracks, corro-
sion or damage.
NOTE:
Clean wheel cylinder components with brake fluid.
INSTALLATION
1) Take off bleeder plug cap from brake pipe and connect pipe to
wheel cylinder (1) just enough to prevent fluid from leaking.
2) Install wheel cylinder (1) to brake back plate (2) to specified
torque.
Tightening Torque
(a): 10 N·m (1.0 kg-m, 7.5 lb–ft)
3) Tighten flare nut (3) of brake pipe to specified torque.
Tightening Torque
(b): 16 N·m (1.6 kg-m, 11.5 lb-ft)
4) Install bleeder plug cap taken off from pipe back to bleeder plug.
5) Install brake shoes.
(Refer to BRAKE SHOE INSTALLATION.)
6) Install brake drum.
(Refer to BRAKE DRUM INSTALLATION.)
7) Fill reservoir with brake fluid and bleed brake system.
(For bleeding operation, refer to AIR BLEEDING OF BRAKE
SYSTEM.)
8) Upon completion of all jobs, depress brake pedal with about 30
kg load three to five times so as to obtain proper drum-to-shoe
clearance.
Adjust parking brake cable.
2
3, (b)
(a)
5-24 BRAKES