Suzuki RA410, Manual

Page: 353 / 761

REMOVAL
1) Disconnect negative cable at battery.
2) Drain coolant.
3) Remove front bumper (see Section 9).
4) Remove exhaust manifold.
5) Remove A/C compressor (1) from its bracket with hose still at-
tached (if equipped), then remove A/C compressor belt.
6) Loosen drive belt adjusting bolt and generator pivot bolt, then
remove water pump bolt.
7) Disconnect oil pressure switch (1) connector and remove
clamp.
8) Remove water pump assembly by removing 4 bolts.
INSPECTION
NOTE:
Do not disassemble water pump.
If any repair is required on pump, replace it as assembly.
1) Rotate water pump by hand to check for smooth operation.
If pump does not rotate smoothly or makes abnormal noise, re-
place it.
2) Inspect water pump impeller (1) for damage.
Replace as necessary.
NOTE:
Do not disassemble water pump to check the water pump
impeller.
1
INSTALLATION
1) Install new O-rings to water pump and water inlet pipe.
ENGINE COOLING 6B-13