Suzuki RA410, Manual

Page: 694 / 761

INSPECTION
Seat belts and attaching parts can affect the vital components and
systems of a vehicle.
Therefore, they should be inspected carefully and replaced with
genuine parts only.
Seat belt
Its webbing or strap should be free from damage.
Retractor assembly
It should lock webbing when pulled quickly.
The front seat belt retractor assembly (1) should pass the above
inspection and should lock webbing even when tilted (approx.
15
) toward the fore and aft or right and left directions.
Check retractor assembly (1) with seat belt pretensioner ap-
pearance visually for following symptoms and if any one of them
is applicable, replace it with a new one as an assembly.
Pretensioner has activated.
There is a crack in seat belt pretensioner (retractor assem-
bly).
Wire harness or connector (2) is damaged.
Seat belt pretensioner (retractor assembly) is damaged or a
strong impact (e.g., dropping) was applied to it.
Anchor bolt
Anchor bolts should be torqued to specification.
Belt latch
It should be secure when latched.
2
1
INSTALLATION
1) Install front seat belts to the vehicle in the same way as INSTAL-
LATION of FRONT SEAT BELT WITHOUT PRETENSIONER.
2) Connect Yellow connector (1) for seat belt pretensioner secure-
ly and fit seat belt pretensioner connector onto body.
a) Connect connector
b) Lock connector with lock lever
3) Connect negative battery cable to battery.
4) Enable air bag system. Refer to ENABLING AIR BAG SYSTEM
under SERVICE PRECAUTIONS in SECTION 10B.
1
b)
a)
a)
1
10-8 RESTRAINT SYSTEM