Suzuki RA410, Manual

Page: 415 / 761

ACCELERATOR CABLE ADJUSTMENT
With accelerator pedal depressed fully, check clearance between
throttle lever (1) and lever stopper (2) (throttle body), it should be
within following specification.
Clearance “b” : 0.5 – 2.0 mm (0.02 – 0.07 in.)
(With pedal depressed fully)
With throttle valve closed, check accelerator pedal play, it should
be within following specification.
Pedal play “a”: 2 – 7 mm (0.08 – 0.27 in.)
If measured value is out of specification, adjust it to specification
with cable adjusting nut (3).
1
2
“a”
“b”
3
IDLE SPEED/IDLE AIR CONTROL (IAC) DUTY
INSPECTION
Before idle speed/IAC duty check, check for following conditions.
Lead wires and hoses of engine / emission control systems are
connected securely.
Accelerator cable has some play, that is, it is not tight.
Valve lash is checked and adjusted according to maintenance
schedule.
Ignition timing is within specification.
All accessories (wipers, heater, lights, A / C, etc.) are out of ser-
vice.
Air cleaner has been properly installed and is in good condition.
ECM/PCM does not detect any malfunction DTC.
After above conditions are all confirmed, check idle speed and IAC
duty as follows.
NOTE:
Before starting engine, place transmission gear shift lever in
“Neutral” (shift selector lever to “P” range for A / T vehicle), set
parking brake and block drive wheels.
6E1-50 ENGINE AND EMISSION CONTROL SYSTEM