Suzuki RA410, Manual

Page: 558 / 761

AUTOMATIC TRANSMISSION 7B-31
3, (a)
1
2
1
(a)
(a)
(A)
INSTALLATION
1) Install shift range switch and tighten shift range switch mounting
bolts temporarily.
2) Install select lever (1) to manual shift shaft and drive spring pin
(2) into shaft.
Special Tool
(A): 09922-89810
3) Put a 3 mm pin (1) (drill, etc.) into hole in switch and positioning
hole in manual shift shaft and fix shaft range switch (“N” posi-
tion).
4) Tighten shift range switch mounting bolt to specified torque.
Tightening Torque
(a): 3.5 N·m (0.35 kg-m)
5) Adjust select cable as previoiusly outlined.
6) Connect transmission range switch connector.
SELECT LEVER
REMOVAL
1) Remove select knob screw and then select knob (1).
NOTE:
Knob and push button must not be disassembled.
2) Remove console box and select indicator assembly (2).
3) Remove select cable from select lever.
4) Raise vehicle
5) Remove housing nuts (3) and then remove lever housing with
select lever from floor.
INSTALLATION
Assemble selector by reversing removal procedure, replacing parts
with new ones as necessary.
Tighten housing nut to specified torque.
Tightening Torque
(a): 20 N·m (2.0 kg-m, 14.5 lb-ft)
NOTE:
Check selector for proper operation as follows.
1. With knob button pushed half way, N to R and D to 2 shifts
are available (but not any other shift).
2. With knob button pushed all the way in, 2 to L and R to P
shifts are available.