Suzuki RA410, Manual

Page: 71 / 761

RADIATOR (AND CONDENSER) COOLING
FAN RELAY
INSPECTION
1) Disconnect negative (–) cable at battery.
2) Remove radiator cooling fan relay (1) from vehicle.
3) Connect battery positive (+) terminal to terminal “b” of relay.
Connect battery negative (–) terminal “a” of relay.
Check continuity between terminal “c” and “d”.
If there is no continuity when relay is connected to the battery,
replace relay.
2. Radiator (and condenser) cooling fan fuse
2
1
a
c
d
b
a
c d
b
1
COMPRESSOR
REMOVAL
1) RUN engine at idle speed with air conditioning ON for 10 min-
utes. After that stop the engine.
2) Disconnect negatige (–) cable at battery.
3) Recover refrigerant from refrigeration system by using recovery
and recycling equipment.
4) Remove front bumper.
5) Disconnect magnet clutch lead wire (1) and undo lead wire
clamp (2).
1
2
6) Disconnect suction and discharge hoses from compressor.
NOTE
Cap open fittings immediately to keep moisture out of sys-
tem.
7) Remove compressor drive belt by loosening compressor bolt.
8) Remove compressor with magnet clutch assembly (3) from its
mount as shown.
9) If compressor is replaced.
Drain oil from compressor, and measure its amount.
3
INSTALLATION
Reverse removal procedure noting the following point.
If compressor is replaced, pour new compressor oil with the
same amount as that drained from compressor in REMOVAL.
Refer to “REPLENISHING COMPRESSOR OIL” in this section.
Evacuate and charge system according to previously described
procedure.
1. New compressor
2. Removed
compressor
3. Excess oil (A–B)
AIR CONDITIONING (OPTIONAL) 1B-19