Suzuki RA410, Manual

Page: 453 / 761

CMP Sensor Resistance
1) Disconnect distributor lead wire coupler (1).
2) Measure resistance of CMP sensor by using ohmmeter.
CMPsensor resistance: Approx. 735 (at 20 C/68 F)
3) If resistance is out of specification, replace CMP sensor as fol-
lows.
4) Remove distributor cap and rotor.
5) Remove CMP sensor securing screws.
6) Replace CMP sensor.
7) Adjust signal rotor air gap to specifications as previously out-
lined.
8) Install rotor, distributor cap seal and cap.
1
IGNITION TIMING
NOTE:
Before starting engine, place transmission gear shift lever in
“Neutral” (shift select lever to “P” range for A/T model), and
set parking brake.
INSPECTION AND ADJUSTMENT
1) Set timing light to No. 1 high-tension cord.
2) Fix ignition timing to initial one as follows:
a) Connect D and E terminals of monitor coupler (1) by using
service wire so that ignition timing is fixed on initial one.
1
D
E
3) Using timing light (1), check that timing is within specification.
Initial ignition timing (Test switch terminal grounded):
5
1 BTDC (at idle speed)
Ignition order 1-3-4-2
2. Crankshaft pulley
3. Water pump pulley
2
3
1
6F1-10 IGNITION SYSTEM