Suzuki RA410, Manual

Page: 506 / 761

6) Remove 8 bolts and take off transmission side cover.
7) Using special tool, remove circlip (1) and then hub plate (2).
CAUTION:
Care should be taken not to distort side cover when
it is removed from left case.
8) Remove shift fork plug (1) and guide ball.
NOTE:
Use of magnet would facilitate removal of guide ball.
9) Drive out spring pin (2) using special tool and hammer and re-
move circlip (3).
Special Tool
(B): 09922-85811
10) Remove gear shift fork (1), sleeve & hub assembly (2), syn-
chronizer ring and 5th gear all together.
1
2
11) Remove counter shaft nut (1) as follows:
a. Shift low speed gear shift shaft (2) to 1st gear position and
high speed gear shift shaft (3) to 3rd gear position.
b. Loosen nut with above double engagement.
12) Remove input shaft 5th gear, needle bearing and counter shaft
5th gear. Gear puller would be necessary if spline fitting of
counter shaft 5th gear is tight.
3
2
1
MANUAL TRANSMISSION 7A-13