Suzuki RA410, Manual

Page: 129 / 761

MOTOR AND CLUTCH
ON-VEHICLE INSPECTION
1) Remove steering column hole cover.
2) Disconnect coupler (1) for motor and clutch from P/S control
module with ignition switch OFF.
3) Check resistance between terminals of coupler (1) for motor
and clutch.
If check result is not as specified above, replace steering col-
umn assembly.
4) Check continuity between terminal of motor and clutch coupler
and body ground.
If check result is not as specified above, replace steering col-
umn assembly.
B3 B4
B1 B2
1
STEERING COLUMN ASSEMBLY
Refer to “STEERING WHEEL AND COLUMN” section for removal
and installation of steering column assembly but perform the fol-
lowing step beforehand.
D
Disconnect all couplers from P/S control module.
3B1-22 ELECTRICAL POWER STEERING (P/S) SYSTEM
“B1” and “B2” (For motor) About 1
“B3” and “B4” (For clutch) About 12 (at 20 C (68
_
F))
“B1” and body ground No continuity
“B3” and body ground No continuity