Suzuki RA410, Manual

Page: 178 / 761

3) Install shock absorber (1) lower side to rear axle.
Tighten shock absorber lower nut (2) temporaliry at this step.
2
1
4) Install lateral rod (1) to vehicle body, refer to figure for proper
installing direction of bolt (2).
Tighten nut (3) temporaliry at this step.
5) Remove floor jack from rear axle.
6) Install wheel and tighten wheel nuts to specified torque.
Tightening Torque for wheel nuts
(a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
7) Lower hoist.
Be sure that vehicle is off hoist and in non loaded condition.
FORWARD
2
3
2
8) Tighten front, center and rear trailing arm nuts (1), shock ab-
sorber lower nuts (2) and lateral rod right nut (3) to specified
torque (right and left).
NOTE:
When tightening these nuts, be sure that vehicle is off hoist
and in non loaded condition.
Tightening Torque
(a): 90 N·m (9.0 kg-m, 65.0 lb-ft)
(b): 80 N·m (8.0 kg-m, 58.0 lb-ft)
(c): 25 N·m (2.5 kg-m, 18.0 lb-ft)
(d): 65 N·m (6.5 kg-m, 47.0 lb-ft)
2, (c)
3, (d)
1, (a)
1, (b)
REAR SUSPENSION 3E-11