Suzuki RA410, Manual

Page: 747 / 761

REMOVAL
1) Disconnect negative cable at battery.
2) Open glove box (1), then while pressing glove box stopper, pull
out glove box (1) from instrument panel (4) and then remove
glove box circlip (2) and glove box (1) from instrument panel (4).
3) Disable air bag system. Refer to DISABLING AIR BAG SYS-
TEM of SERVICE PRECAUTIONS in this section.
4) Remove passenger air bag (inflator) module (3) attaching bolts
(6) and screws (5) and passenger air bag (inflator) module (3)
from vehicle.
1
4
2
4
3
Push
Push
Pull
6
5
5
INSPECTION
WARNING:
Never measure resistance of passenger air bag (inflator)
module or disassemble it. Otherwise personal injury may
result.
CAUTION:
If air bag (Inflator) module was dropped from a height or
90 cm (3 ft) or more, it should be replaced.
Check air bag (inflator) module appearance visually for following
symptoms and if any one of them is applicable, replace with a new
one.
Air bag has deployed.
There is a crack in trim cover (pad surface).
Wire harness or connector is damaged.
Air bag (inflator) module is damaged or a strong impact was ap-
plied to it.
10B-52 AIR BAG SYSTEM
PASSENGER AIR BAG (INFLATOR) MODULE (IF EQUIPPED)
WARNING:
Never attempt to disassemble or repair the passenger air bag (inflator) module. If any abnormality
is found, be sure to replace it with new one as an assembly.
Be sure to read SERVICE PRECAUTIONS in this section before starting to work and observe every
precaution during work. Neglecting them may result in personal injury or undeployment of the air
bag when necessary.