Suzuki RA410, Manual

Page: 589 / 761

7B-62 AUTOMATIC TRANSMISSION
1. Race incorporated type bearing
2. Race incorporated type bearing
3. Race incorporated type bearing
4. Race incorporated type bearing
5. Needle bearing (with race on one side)
6. Needle bearing/race
7. Bearing
8. Race
9. Output shaft
10. Rear internal gear assembly
11. Low reverse brake
12. Planetary carrier
13. One-way clutch
14. Sun gear
15. Front planetary carrier
16. Forward clutch
17. Front planetary carrier
18. Direct clutch
19. Oil pump
20. Input shaft
ASSEMBLING UNIT
CAUTION:
Automatic transmission consists of highly precise parts. As even a flaw in a small part may cause fluid
leakage or decrease in function, check each part carefully before installation.
Clean all parts with compressed air. Never use wiping cloths or rags.
Before assembling new clutch discs and brake band, soak them in automatic transmission fluid for
at least 2 hours.
Be sure to use new gaskets and O rings.
Lubricate O rings with automatic transmission fluid.
Apply automatic transmission fluid on sliding or rotating surfaces of the parts before assembly.
Use yellow petrolatum grease or Suzuki super grease C to retain parts in place.
Be sure to install thrust bearings and races in correct direction and position as shown in figure below.
Make sure that snap ring ends are not aligned with one of cutouts and are installed in groove correctly.
Do not use adhesive cements on gaskets and similar parts.
Be sure to torque each bolt and nut to specification.