Suzuki RA410, Manual

Page: 29 / 761

MAINTENANCE SERVICE
ENGINE
ITEM 1-1
Drive Belt Inspection and Replacement
Water pump belt inspection
1) Inspect belt for cracks, cuts, deformation, wear and cleanliness.
Replace if any defect exists.
2) Check pump belt for tension and adjust if it is out of specifica-
tion.
Water pump belt tension “a”:
12 – 15 mm (0.47 – 0.59 in.) deflection under 10 kg or 22 lb
pressure
NOTE:
When replacing belt with a new one, adjust belt tension to
8 – 9 mm (0.31 – 0.35 in.).
Water pump belt replacement
Replace belt referring to “Water Pump Belt Removal and Installa-
tion” in Section 6B.
1. Water pump pulley
WARNING:
Disconnect negative cable at battery before checking
and replacing belt tension.
A/C compressor drive belt inspection (If equipped)
Inspect belt for wear, deterioration and tension.
Replace or adjust if necessary.
A/C compressor drive belt tension “b”:
8 – 9 mm (0.31 – 0.35 in.) deflection under 10 kg or 22 lb pres-
sure
A/C compressor drive belt replacement
1) Disconnect negative cable from battery.
2) Loosen belt tension and replace belt with new one.
3) Adjust belt tension to specification.
4) Connect negative cable to battery.
Vehicle with A/C
1. A/C compressor pulley
MAINTENANCE AND LUBRICATION 0B-5